Compression springs are used in many areas such as valve parts, contacts and control system parts.
They are indispensable springs for engineering, hydraulic, automotive, measurement and control systems.
Depending on the area of use, we can produce appropriately according to the load, deformation, intensive use, pressure level and other factors of the compression springs. We organize this process according to material selection, diameter selection, spring length, shape, pitch and heat treatment values.
If there are special inquiry for production, it will be sufficient to share technical documents and sample parts with us. We will support you in the design, development and production areas.
Our most intensive production is tight wound springs, intensive load limits and intermittent parts.
Compression springs are used for high dynamic loads, and even when used under thermal stress, they can maintain their high sensitivity thanks to cutting, heat treatment and adjustments. After production, the springs must undergo multi-level quality control, which includes length, load and edge tests, allowing us to achieve low tolerance values.
What you will have :
Production precision
Correct twist ratio
Angle sensitivity depending on your request
limited relaxation
Optimal brightness
Material ;
A, B, C, D quality phosphated/galvanized spring steel wire or stainless steel wire
Wire diameter from 0.20 to 12.00 mm
Figures ;
Cylindrical, ground, double cylindrical, conical
Plating and heat treatment.
Galvanized, electrolytic painted or coatings upon your request.
